Masking product

UV-Curable Masking Resins: CM Mask
· Masking Resins cure with UV Light, easy to apply & remove

· For use in industries including aerospace & medical implants

· Available in Peelable & Burn-Off Grades

Simplify your Masking Process prior to surface preparation & finishing operations. Formulated to have no effect on alloys, CM Mask cures in seconds upon exposure to UV light; offering increased productivity, lower assembly costs and enhanced worker and environmental safety. When cured with UV lamps, this resin provides optimum process flexibility. CM Mask UV-Curable Masking Resins are easy to apply and cure in seconds.

BENEFITS
1.Apply & Cure in Seconds
2.Simplifies Masking Process
3.Easy to Use
4.Environmentally Friendly
5.Leaves No Residue
6.Faster Than Other Masking Methods

INDUSTRIES
1.Medical Implants & Devices
2.Metal Finishing
3.Aerospace

APPLICATIONS
1.Grit Blasting
2.Shot Peening
3.Plating
4.Acid Stripping
5.Plasma Spray Coating
6.Painting

PEELABLE GRADES
1.Lower adhesion grades have easy manual peel off
2.Higher adhesion grade peels off easily after warm water soak
3.Plating grade is plating solution resistant, peels off easily after warm water rinse
4.Leaves no residue
5.Spray, brush or dip to apply

BURN-OFF GRADES
1.High adhesion; resists HCI and other acids/alkalis
2.Cures to 1/4" deep
3.Tough, translucent bonds
4.Machines and abrades cleanly
5.Leaves no residue
6.Cooling Cavity Sealant
7.Available with hard, clear and glossy bonds
8.Non-slumping resin
9.Applications where heat cure is not practical

Flowspec Industrial Limited is one leading walnut shell manufacturer with almost 30 years' experience which can manufacture wide range of walnut shell powder, walnut shell blasting, walnut shell filter and walnut shell abrasive with mesh no. 4#, 5#, 6#, 7#, 8#, 10#, 12#, 14#, 16#, 18#, 20#, 24#, 26#, 30#, 36#, 40#, 60#, 80#, 100#, 120#, 160#, 200#, 240#. If you have any need and inquiry on walnut shell, welcome to visit our website of www.walnutshellpowder.com, and contact us at email of walnut@flowspecs.com.